Viking Appliance Repair Phoenix, AZ (480) 666-4248
Menu

03 Phoenix · Viking

Viking Oven Repair

Calibration, elements, igniters, latches and control panels on Viking wall ovens and range ovens.

Open oven cavity on a stainless gas range, rack shelves bare and one rack standing on the tile floor

How people describe it on the phone.

  1. Everything bakes dark or pale whatever the dial is set to
  2. Door still locked shut after a self-clean cycle
  3. Touch panel ignoring half the keys you press
  4. Lower cavity of a double oven never keeping up with the upper

Any one of these is enough to work with. What changed, and when it changed, is worth more than a guess at the part.

What actually gets measured.

Calibration
A probe in the cavity through a full cycle against the setpoint. Everything baking dark or pale is usually the sensor or the offset, not the element.
Heat delivery
Element and igniter draw under load, relay behaviour on the board, and convection motor current — the three things that make a cavity slow.
Door and latch
Self-clean lock motors, cam position and hinge spring tension. A door still locked after a clean cycle is mechanical far more often than electronic.

03 In their words

Oven Repair calls, told by the people who booked them.

Three Phoenix jobs on this side of the Viking kitchen — the symptom, the fault, the fix.

4.9 / 51,282 reviews

  • Everything came out too dark whatever we set the dial to. Somebody had left a calibration offset in it, and a relay was sticking on top of that. Both fixed. Wide arrival window, hence four.

    Solveig M.North Central Phoenix

  • Half the touch keys stopped responding, so we could not even set a timer on it. The ribbon behind the panel had failed, which he found without pulling the whole oven out of the wall. Part was on his van.

    Halvor K.Biltmore

  • Self-clean finished and left the door locked with the oven dead. The latch motor had stalled halfway round. He freed it, replaced the switch, and we had the oven back before dinner.

    Corinne V.Arcadia

04 What a repair costs

What oven repair costs here.

Every figure below is a range covering parts and labour on Viking equipment. Which end of it you land on depends on the part and how far into the machine it sits — that is a thing to be measured, not guessed at over the phone.

Igniter or burner assembly
$170–$450
Oven thermostat or heating element likely here
$200–$430
Refrigeration fan or defrost system
$280–$680
Dishwasher pump or control
$200–$400
Control board or touch panel likely here
$430–$670
Compressor or sealed-system repair
$1,430–$3,120

Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.

The number is agreed before anything is dismantled. You get the band, then the firm figure once the fault is confirmed on site, and the work starts only after you say yes to it — so the $89 you have already paid comes straight back off the bill.

06 Book the visit

Oven Repair in Phoenix?

Say what it is doing and roughly when it started. Most oven repair faults narrow to two or three candidates before anyone gets in the van.

8:00 am – 8:00 pm, seven days on the road · phone answered 24/7

Appliance kit on a cloth: brush, five nut drivers, pliers, a pulley, a spring and hinge plates with bolts